Image 1 of 9
Image 2 of 9
Image 3 of 9
Image 4 of 9
Image 5 of 9
Image 6 of 9
Image 7 of 9
Image 8 of 9
Image 9 of 9
Related Products
The cast intake horn on the Cummins is a known choke point. This intake horn is made from 3 inch stainless steel and helps smooth the air flow as it enters the intake manifold. Paired with the PQY intake heater block delete this kit removes all the restriction for the charge air. It not only makes performance gains but looks much better too.
Kit comes with everything you will need to install it.
-3 inch Stainless steel intake horn.
-(4) M8×1.25×75 bolts
-3 inch to 2 inch silicone coupler
-(2) T-bolt clamps
This intake Kit completely replaces the stock intake. Its large filter and 4" diameter pipe allows your 12 valve to breath much better and make far more power. Its made from stainless steel and is fully TIG welded. It comes with all the clamps and coupler to install it. Not only will this intake help lower your EGT's, it will look great while doing it. Pair it with our Full 3" piping kit to give your truck a "Custom Fab" look.
4" stainless steel intake tube
4" straight coupler
(x3) 4" clamps
8.5x 12" air filter.
The OEM 2.5" piping and cast intake horn on the first gen Cummins is a known choke point. This pipping kit is made from 3 inch stainless steel and helps smooth the air flow as it enters the intake manifold. The intake horn will work with the OEM gride heater or paired with the PQY intake heater block delete this kit removes all the restriction for the charge air. It not only makes performance gains but looks much better too.
This intake horn will work with a P-Pump set up.
Kit comes with everything you will need to install it.
-3 inch Stainless steel intake horn, Cold side pipe and hot side pipe.
-(4) M8×1.25×75 bolts.
-New gasket for intake horn.
-(3) 3 inch to 2.5 inch silicone coupler.
-3 inch silicone coupler.
-(8) T-bolt clamps
