Image 1 of 8
Image 2 of 8
Image 3 of 8
Image 4 of 8
Image 5 of 8
Image 6 of 8
Image 7 of 8
Image 8 of 8
Related Products
The cast intake horn on the Cummins is a known choke point. This intake horn is made from 3 inch stainless steel and helps smooth the air flow as it enters the intake manifold. Paired with the PQY intake heater block delete this kit removes all the restriction for the charge air. It not only makes performance gains but looks much better too.
Kit comes with everything you will need to install it.
-3 inch Stainless steel intake horn.
-(4) M8×1.25×75 bolts
-3 inch to 2 inch silicone coupler
-(2) T-bolt clamps
The OEM 2.5" piping and cast intake horn on the first gen Cummins is a known choke point. This pipping kit is made from 3 inch stainless steel and helps smooth the air flow as it enters the intake manifold. The intake horn will work with the OEM gride heater or paired with the PQY intake heater block delete this kit removes all the restriction for the charge air. It not only makes performance gains but looks much better too.
This intake horn will work with a P-Pump set up.
Kit comes with everything you will need to install it.
-3 inch Stainless steel intake horn, Cold side pipe and hot side pipe.
-(4) M8×1.25×75 bolts.
-New gasket for intake horn.
-(3) 3 inch to 2.5 inch silicone coupler.
-3 inch silicone coupler.
-(8) T-bolt clamps
The second gen Holset HX35 or HX40 are a huge upgrade for the first gen 12V Cummins trucks. This intake horn is made from 3 inch stainless steel and helps smooth the air flow as it enters the intake manifold. It is designed to work with both the HX35 and HX40 turbos. Paired with the PQY intake heater block delete this kit removes all the restriction for the charge air. It not only makes performance gains but looks much better too.
Kit comes with everything you will need to install it.
-3 inch Stainless steel intake horn.
-(4) M8×1.25×75 bolts.
- New gaskets for intake horn.
-3 inch to 2.5 inch 45° silicone coupler
-(2) T-bolt clamps
- V-band to 2.5" adaptor
