Image 1 of 7
Image 2 of 7
Image 3 of 7
Image 4 of 7
Image 5 of 7
Image 6 of 7
Image 7 of 7
Related Products
This is a 5” diameter intake for the 94-02 5.9L Cummins. It will fit your stock turbo or any bolt on aftermarket turbos. It is made from 304 stainless steel and is fully TIG welded. Unlike other intakes that use a large 45° coupler that can collapse under high boost. This intake only uses a small reducer coupler or a straight 5” coupler. It comes with everything needed to install it.
Not only will this intake look great it really makes the turbo sing. Add a heat shield to the kit for maximum HP gains.
This set is for the 24V Cummins 1998-2002. Intake horns for the 12V 1994-1998 are available. Please check other listings
This intake horn is made from 3.5 inch stainless steel and helps smooth the air flow as it enters the intake manifold. Paired with the PQY intake heater block delete this kit removes all the restriction for the charge air. It not only makes performance gains but looks much better too.
-3.5 inch Stainless steel intake horn and cold side pipe
-(4) M8×1.25×75 bolts
-3.5 inch straight silicone coupler
-3.5inch 45 degree silicone soupler
-(4) 3.5 inch T-bolt clamps
The cast intake horn on the Cummins is a known choke point. This intake horn is made from 3 inch stainless steel and helps smooth the air flow as it enters the intake manifold. Paired with the PQY intake heater block delete this kit removes all the restriction for the charge air. It not only makes performance gains but looks much better too.
Kit comes with everything you will need to install it.
3 inch Stainless steel intake horn and cold side pipe
(4) M8×1.25×75 bolts
3 inch silicone coupler
(2) 3 inch T-bolt clamps
Gaskets for intake plenum
